Rheo Calibrate (DO NOT USE THIS TUTORIAL UNDER REVIEW)
The Rheostat Receiver is sent to you with preprogrammed settings chosen from a classic iiid to predict the bottom end. If they are too hot or too cold for your liking, read and perform the following.
In order to program your receiver to act like your normal rheostat, a sub menu is used.
To access this menu called heat set, perform the following steps:
receiver plugged in and on
hold the green button down on hand remote startup. You know you did this step correctly when the bottom row, fifth led from the left is lit from this action.
with the hand remote displaying numbers, sweep naturally from min to max and reverse repeating until the screen dims down and says “set min amps”
enter exactly 460
after displaying set max amps, enter 480
done right, it will say “heat set” then “low begin”
now the dial will adjust the rheostat minimum, 0 to 100% (sent to you at 62) Suggested method is to set the hand remote 0 (do not press green) and strike an arc or attempt. gradually rise the number from 0 to 100 until the arc behaves like minimum in the gear you are in. Once it looks like a natural remote rheostat minimum, press the green button and you are done.
TIP: Remember the number you selected, most likely between 45 and 65. If you still want to adjust it again and say your number was 60, adjust in increments of two, “2”, and try again.
If the above process does not work. if the above process produces no change in arc, please email info@dkwremotes.ca and I will address the issue and respond to your concerns immediately.