Clone Mode for EVOX

This page describes what you do when you receive the clone mode.

Clone Mode gets your hand remote programmed to you receiver

1) ensure the receiver and hand remote are off

2) turn on the hand remote only

3) after the hand remote says clone mode “waiting”, wait 5 seconds then plug in the receiver

4) it will detect you personal id and store it in the hand remote. That is step 1 of 3

5) Step 2 will setup the receiver for step 3

6) Step 3 will scan the frequencies looking for a ping from the receiver

7) once identified, it will acknowledge it, reboot the hand remote, and communicate with the receiver

Will not have to do this again