NES Controller Cheat Codes and Instructional Page

The first thing the unit does when it boots up is it goes straight into a Channel Search. It might as well do this because your hand remote and receiver may have jumped frequency while it was off. It will blink rapidly whilst doing this and stop blinking when complete.

This Unit when powered up disables UP5 and DOWN5 buttons for the first fifteen seconds to allow you to perform sub functions such as node swap, repeater mode, channel search and or clone mode. During these fifteen seconds, the LED will not blink until the fifteen seconds expire. A rate of double blink every five seconds is a Transmitter node. Once every five seconds for a hand remote node.

In order to put the unit to sleep, you hold the select button for five seconds. You can let go of the button once you see it rapidly blink. To get it back online, you depress both buttons A and B to which it will blink rapidly but a slower blink. Then, don’t forget it will not go into UP5 Down5 Mode until the fifteen seconds expire. Again, these fifteen seconds are for clone mode, repeater mode and node swap

Swap from hand remote to transmitter: Up, Left, Up, Left, Up, Left, Up, Left, B, A

Repeater: Holding Left (B, A, B, A, B, A) Up, Left, Up

Stinger mode double blinks once every five seconds

• Hand remote blinks once every five seconds

• Repeater Mode begins with escalated blinks then triple blinks every five seconds, plus lights on data transfer

• Clone Mode blinks every half second